Xiaomi Xiaoda Automatic Water Saver Tap Automatic Faucet
(Global Version)
Xiaomi Touchless Faucet Sensor Faucet sink sensor.Sensor automatic water faucet Easy to install by yourself
Xiaomi as Zajia is an accessory that can be attached to a normal faucet in your home.
To become a smart faucet
✔ Automatic shut-off with a sensor✔ Easy to install, do it yourself.
✔ Facilitate
✔ Help save water
Reduce contact with the tap directly. Avoid dirt It has dual IR motion sensor, 2 operating modes and uses water spray technology. At a water flow rate of 0.07L / s, it helps to save more water.
Color: whiteMaterial: Aluminum Alloy
Two sensing modes:
1.Sensor at the bottom (sensing distance 0-10 cm.) For temporary use of water. The water will stop flowing immediately if it is not within the sensing range.
2. Side sensors (sensing distance 0-5 cm.) For large amounts of water The water will flow continuously for about 3 minutes.
To turn it off, put it in the side detecting distance again.
- Detection speed 0.25 seconds
- MCU algorithm technology that facilitates detecting Low power consumption
- Using water spray technology At a water flow rate of 0.07L / s, it helps to save more water.
- IPX6 waterproof rating (protected against water spray Can not be immersed in water for a long time)
- Standby power: less than or equal to 0.2mW
- Comes with 6 standard size couplings that can fit most taps:
- Inner thread: M20 M22 G1 / 2
- Outer thread: M20 M22 M24
- Charging port: Micro USB
- It takes about 3 hours to fully charge, it can be used for up to 6 months.
- Water pressure suitable for use: 0.05 - 0.8MPa
- Water temperature suitable for use: below 75 degrees
- Size: 60 x 34 x 49mm.
- Weight: 105g
What you will receive
Xiaomi ZAJIA Smart Automatic Water Saving Device x1
Wrench x1
Faucet joint x6
Silicone ring x3
Manual x1